![]() ![]() Wait a moment for the print core 2 to cool down.Confirm by pushing the button when you can see the new material extrudes front of the print core.Wait for the print to head up the print core.Wait for the print to load the material into the print core.When using Ultimaker material, Wait until the Ultimaker print detects the material and then select ”confirm”.Confirm by pushing the button at the front side of the Ultimaker Extented 3 when you have inserted the material.Push the feeder knob through up and at the same time, pull the material 1. Insert and push the end of material 2 into feeder 2.If it doesn’t look good, cut the tip of the material. Check the shape of the tip of the material. Make sure that the spool material is in clockwise direction. Place the spool material 2 on the spool holder. Select ”Load” when the spool material is not installed before. Select the ”Material 2” and then ”Change”. If you need to change the print core, see the Ultimaker print core manual.Ģ.2.1 Material 2 Go to the menu ”MATERIAL/PRINT CORE” by rotating and then pushing the button at the front side of the 3D print. Begin to put material 2 on the spool holder. ![]() Open the print head fan bracket and make sure the type of the print cores is compatible with the material that you want to use. See below, the combinations if you wish use the two materials First, choose your material spool (PLA, ABS, PLA…) on the shelf above the 3D print.Select the ”confirm” option on the display panel when you have removed the material spool from the spool holder. Pull the spool holder and then slide the spool material 2. Remove the material from the spool holder 1. Push the feeder knob through up and at the same time, pull the material 3. If you cannot remove the material from feeder 1. Remove the material from the feeder holder 2.Wait for the print 1 or print 2 core to head up remove from print 2.Go to the menu ”Change” or ”unload” (when you don’t wish to replace the spool).Select ”Material 1” if you change spool 1 and select ”Material 2” to change spool 2.Ing the button at the front side of the Ultimaker Extented 3. Go to the menu ”MATERIAL/PRINTCORE” by rotating and then push.If not, You need to load materials into the printer, see below. Make sure you have enough materials on the spool holder. Close the two build plate clamps at the front to the glass plate 2. And then slide the glass plate onto the build plateīack the glass plate onto the build plate 1. Open the two build plate clamps at the front to secure the glass plate 2. Make sure that the glass plate is completely clean and free of any materiels and fingerprints.Turn on the printer with the power switch at the back.Materials: PLA, ABS, PVA, Flexible, TPU 95A, Glass Bend.Print core BB 0,4mm (for support material PVA).Nozzle diameter : two types of print cores.Ultimaker extended 3 : Fused Deposition Modeling (FDM).This instruction manual describes the basic operations of the Ultimaker Extended 3 print.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |